C H A P T E R 3
Changing the flow control
on a port
Purpose
Changing the state of a
port
Standard Configuration
Flow control prevents the loss of frames during busy periods. To
change the flow mechanism on a port:
Note
This feature is over-ridden by disabling the flow control set-
ting in Device Setup>Switching .
1
Click the port you want to change.
2
Select Port Setup .
3
Click Port Mode .
4
In Flow Control , click the flow control you want.
Default uses the same flow control as specified in Device
Setup.
5
Click OK .
Port Specific Spanning Tree
You can:
•
View the Spanning Tree setups for the port
•
Specify whether STP (Spanning Tree Protocol) is enabled on the
port
Define which ports are going to be used most frequently
•
To specify that a port is using STP:
1
Click the port you want to change.
2
Select Port Setup .
61