Intel Express 510T User Manual page 18

C H A P T E R 1
In an equipment rack
Ambient temperature
8
Intel Express 510T Switch
Customer-supplied screws for securing the switch in the rack.
•
Mounting screws are not provided because the required sizes
may vary from rack to rack.
To mount the switch in a standard equipment rack:
1 Attach the mounting bracket marked "Left" to the left-hand side
of the switch, and attach the mounting bracket marked "Right"
to the right-hand side of the switch, using the four screws pro-
vided.
1 2
Make sure that you attach the mounting brackets to the correct
sides. Otherwise the switch will not align correctly in the
equipment rack.
2 If the four rubber feet prevent the switch from standing firmly
on the equipment rack's side support rails, remove them.
3 Set the switch in the equipment rack, and make sure there is
adequate space for air flow around the switch (see "Allow ade-
quate ventilation" in "Positioning and Installing the Switch", p.
7).
4 Screw the mounting brackets securely to the equipment rack.
If the switch is installed in a closed or multi-rack assembly, the oper-
ating ambient temperature of the rack environment may be greater
than the ambient temperature of the room. Make sure that the temper-
ature of the rack environment does not exceed the recommended op-
erating temperature for the switch.
Slot B
Slot A
12 13 14 15
5 6 7 8 9 10 11
3 4
LEDs Green Orange
10 Mbps Half duplex
Off Intel Express
Solid 100 Mbps Full duplex
510T Switch
Port Status
Power
Status
LEDs Green Orange
Temperature
Link Disable
Solid Reset
Blink Activity Collision RPS
20 21 22 23 24 Console
16 17 18 19
9600-8-N-1