Kenmore 415. 16125800 Use And Care Manual

Kenmore 415. 16125800 Use And Care Manual

Liquid propane gas grill
Hide thumbs Also See for 415. 16125800:

Advertisement

Quick Links

Use and Care Guide
Liquid Propane Gas Grill
Kenmore Model No. 415. 16125800
This Grill Is For
Outdoor Use Only
WARNING
• Read this manual before cooking on
grill. Failure to follow all
manufacturer's instructions could
result in fire or explosion which could
cause property damage, personal
injury or death.
• Combustion by-products produced
when using this product contain
chemicals known to the State of
California to cause cancer, birth
defects, or other reproductive harm.
CAUTION
• Read and follow all Safety
Statements, Assembly Instructions
and Use & Care Directions before
attempting to assemble and cook.
• Some parts may contain sharp edges,
especially as noted in these
instructions. Wear protective gloves
if necessary.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
©2007 Sears, Roebuck and Co., All Rights Reserved
• Parts
• Assembly
• Safety Rules
Assembly Questions?
Call 1-800-241-7548
Parts Ordering:
Call 1-800-4-MY-HOME
To Installer/Assembler: Leave
these instructions with
consumer.
To Consumer: Keep this
manual for future reference.
Printed in China
• Use and Care
• Troubleshooting
®
464310408 • 80015598 • 12-06-07

Advertisement

Table of Contents
loading

Summary of Contents for Kenmore 415. 16125800

  • Page 1 Use and Care Guide Liquid Propane Gas Grill Kenmore Model No. 415. 16125800 This Grill Is For Outdoor Use Only WARNING • Read this manual before cooking on grill. Failure to follow all manufacturer’s instructions could result in fire or explosion which could cause property damage, personal injury or death.
  • Page 2: Safety Symbols

    DANGER WARNING CALIFORNIA PROPOSITION 65 If you smell gas: 1. Combustion by-products produced when using this product contain chemicals known to the State of 1. Shut off gas to the appliance. California to cause cancer, birth defects, and other reproductive harm. 2.
  • Page 3: Table Of Contents

    Kenmore Grill Warranty ....... 3 Use and Care........4-11 Five-Year Limited Warranty on Burners Parts List.
  • Page 4: Use And Care

    LP Tank USE AND CARE • The LP tank used with your grill must meet the following requirements: DANGER • Use LP tanks only with these required measurements: 12" (30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.) capacity maximum.
  • Page 5 LP Tank Exchange Connecting Regulator To The LP Tank 1. LP tank must be properly secured onto grill. (Refer to • Many retailers that sell grills offer you the option of replacing your empty LP tank through an exchange service. Use only assembly section.) those reputable exchange companies that inspect, precision fill, 2.
  • Page 6 Leak Testing Valves, Hose and Regulator 1. Turn all grill control knobs to OFF. 2. Be sure regulator is tightly connected to LP tank. 3. Completely open LP tank valve by turning OPD hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately.
  • Page 7 Safety Tips WARNING Before opening LP tank valve, check the coupling nut for tightness. For Safe Use Of Your Grill And To Avoid Serious When grill is not in use, turn off all control knobs and LP tank Injury: valve. •...
  • Page 8 Main Burner Ignitor Lighting Before Your First Cookout Do not lean over grill while lighting. • Light burners, check to make sure they are lit, close the lid and 1. Open lid during lighting. warm up grill on HIGH for 15 minutes. This curing of paint and 2.
  • Page 9: Spider Alert

    • Plastic parts: Wash with warm soapy water and wipe dry. Cleaning the Burner Assembly Do not use citrisol, abrasive cleaners, degreasers or a Follow these instructions to clean and/or replace parts of burner concentrated grill cleaner on plastic parts. Damage to and assembly or if you have trouble igniting grill.
  • Page 10: Indirect Cooking

    Indirect Cooking Storing Your Grill Poultry and large cuts of meat cook slowly to perfection on the • Clean cooking grates. grill by indirect heat. The heat from selected burners circulates • Store in dry location. gently throughout the grill, cooking meat or poultry without the •...
  • Page 11: Parts List

    PARTS LIST – Model No. 415.16125800 Description ......Part # Description ......Part # Right Leg Assembly .
  • Page 12 PARTS DIAGRAM – Model No. 415.16125800 12 • 464310408...
  • Page 13 ASSEMBLY – Model No. 415.16125800 Tank Exclusion Wire ‘ Place legs as shown (A). Left leg assembly has large axle holes on ends of legs. Hook tank exclusion wire into right and left leg assemblies (B). Tank Exclusion Wire Match Holder Right Leg Assembly Left Leg Assembly 464310408 •...
  • Page 14 Bottom Shelf to Legs ‘ Place bottom shelf end with cut out hole for LP cylinder between legs with axle holes. Attach to right and left leg assemblies with (4)1/4-20x1-1/2" screws and 1/4-20 flange nuts. ‘ Tighten securely. 1/4-20 Flange nuts Qty.
  • Page 15 Wheels and Leg Extenders to Cart ‘ Turn assembly upside down. “ Insert axle rod through wheel, wheel spacer, legs, wheel spacer and other wheel. Attach with (1) 8mm flat washer and hitch pin. “ Hammer leg extenders into right legs. Hitch Pin Wheel Spacer Qty.
  • Page 16 Front Panels ‘ Stand cart upright. “ Attach one front panel to lower half of cart with (4) #8x3/8" self-tap screws. “ Slide slot in other panel onto tank exclusion wire and attach to upper half of cart with (4) #8x3/8” self-tap screws. #8x3/8"...
  • Page 17 Grill Head to Cart • This step requires two people to lift and position grill head onto cart. • Carefully lower the grill head onto the cart. Make sure the regulator hose is hanging outside the cart. Attach with (4) 1/4-20x1/2"...
  • Page 18 Right Side Shelf ‘ Hook side wall of shelf over support brackets on side of firebox (A). ‘ 7mm fiber washers 1/4-20x1/2" screws Insert (2) through inside front of firebox and (2) through outside back of firebox for each side as shown (B). ‘...
  • Page 19 Side Burner Shelf ‘ Hook side wall of side burner shelf over support brackets on side of firebox (A). ‘ fiber washers 1/4-20x1/2" screws (B). Inside firebox insert as shown ‘ Attach shelf using fiber washers and 1/4-20 flange nuts on each side (C). Lid removed for clarity 1/4-20x1/2"...
  • Page 20 Sideburner Valve, Sideburner, Sideburner Bezel, Ignitor Wire, Control Knob and ‘ Position valve behind fascia and line up holes. ‘ Insert (1) of the #8-32x3/8” stainless steel screws, do not fully tighten. ‘ Slip bezel under screw inserted and position as shown (A). ‘...
  • Page 21 Heat Diffusers ‘ Place heat diffusers over burners by inserting tabs into slots in front of firebox. Opposite ends of heat diffusers rest on pins in back of firebox. Heat diffuser Cooking Grate ‘ Place cooking grates onto grate rests. Cooking Grate 464310408 •...
  • Page 22 Handle Light ‘ Place right handle end cap and handle fiber washer onto lid and attach with 1/4-20x3/4” machine screws, 7mm flat washers, 7mm fiber washers and 1/4-20 flange nuts. (A). ‘ (B). Insert handle bar into right handle end cap Make sure the slot on the handle bar align with the rib on the right handle end cap (E).
  • Page 23 Swing Away ‘ Insert ends of Swing Away pivot wire into holes in sides of grill lid. Insert ends of Swing Away leg wire into holes in sides of firebox. NOTE: Pivot and leg wires, running side-to-side, should be under wires running front-to-back. If pivot and leg wires are on top, Swing Away is installed upside-down.
  • Page 24 LP Tank ‘ LP tank is sold separately. Use only with an OPD (over-fill protection device) equipped LP tank. Fill and leak check before attaching to grill and regulator. “ Place LP tank into hole in bottom shelf with tank collar opening facing to side as shown. Finger tighten tank thumbscrew to hold LP tank securely in place.
  • Page 25: Troubleshooting

    Troubleshooting EMERGENCIES: If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Emergencies Possible Cause Prevention/Solution Gas leaking from • Damaged hose. • Turn off gas at LP tank. If hose is cut or cracked, replace cracked/cut/burned valve/hose/regulator.
  • Page 26 Troubleshooting (continued) Problem Possible Cause Prevention/Solution Burner(s) will not light • Push-button sticks at bottom.. • Replace ignitor. using ignitor. • Sparking between ignitor and electrode. • Inspect wire insulation and proper connection. Replace wires if insulation is broken. • See “GAS ISSUES:” on previous page. Burner(s) will not match light.
  • Page 27 Troubleshooting - Electronic Ignition Problem (Ignition) Possible Cause Check Procedure Prevention/Solution SECTION I • Battery not installed • Check battery orientation. • Install battery (make sure that “+” and “–” No sparks appear at properly. connectors are oriented correctly, with “+” end up any electrodes when ignition button is and “–”...
  • Page 28 Get it fixed, at your home or ours! Your Home For repair–in your home–of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner’s manuals that you need to do-it-yourself.

Table of Contents