Infrared Remote Controller - Carrier 42 HWX Owner's Manual

42 HWX / HQX

Infrared remote controller

Fix to the wall the remote control holder using the screw.
The remote controller operates with two 1.5 V non re-chargeable
batteries, type IEC LR03.
A fading display and reduced controller operating range indicate that
the batteries are exhausted.
How to insert batteries:
Open sliding cover.
Press
Remove the cover by pressing on the plastic catch at the rear of
the controller.
M O D E
T E M P E R A T U R E T U R E
T E M P E R A
T I M E R T I M E R
C L O C K
A I R
GB - 4
A
B
C
D
E
F
G
H
I
J
K
L
M
Insert batteries paying attention to the correct polarity indicated in
the battery compartment; replace cover.
The maximum operating range for the remote controller is approx. 6 m.
No obstructions such as curtains or plants should be between controller
and unit. Direct sun on the unit receiver may interfere with good
signalreception.
The controller must be directed toward the unit receiver when pressing
the buttons of the desired functions. An acoustical acknowledgement
sound (beep) will indicate that signal has been received. If the signal has
not been received, renewed transmission is necessary by pressing any of
the buttons E, F, L or J situated under the sliding cover. After the
acknowledgment (beep), check the function displayed on the controller
readout and adjust or modify the selection made, if necessary. During
signal transmission symbol 1
page). When symbol 1 is lit it is not possible to send other signals.
A new signal can be sent only after symbol 1
A. Display readout
B. On/Off button
C. Timer mode On/Off button
D. Mode selection button
E. Increase temperature button
F. Decrease temperature button
G. Timer program selection button
H. Set clock or timer hour button (Up)
I. Set clock or timer hour button (Down)
J. Fan speed selection button
K. Night mode button
L. Function not enabled
M. Clock set button
BEEP
will appear on the display (see next
has disappeared.