Remote Controller Wiring - Carrier 42TGF0131CP Service Manual

10-3. Remote Controller Wiring

Strip off approx. 9 mm the wire to be connected.
For single system, use non polarity, 2 core wire is
used for wiring of the remote
controller.(0.5 mm² to 2.0 mm² wires)
For the synchronous twin, triple system, use
2-conre shield wire (Vinyl cord for microphone 0.5
to 2.0 mm²) to conform to the EMC standard.
Single system
Remote controller
Remote controller wiring
A B
Indoor side
1 2
Indoor/Outdoor
connecting wires
1 2
Outdoor side
L N
Power supply
3
3
Wiring diagram
Terminal block for remote
controller wiring of indoor unit
A
B
Remote controller
wire (Procured locally)
∗ For details of wiring/installation of the remote
controller, refer to the Installation Manual enclosed
with the remote controller.
- 64 -
Terminal block
Remote
A
controller unit
B