Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents..............................2 Important safeguards..............................3 Accessories ................................4 Installation/Connections............................5...
Important safeguards Using the device at temperature below -10º may cause the breakage of the device. Before using please heat up the passenger compartment to the recommended temperature! Read carefully through this manual to familiarize yourself with this high-quality system. Disconnect the vehicle's negative battery terminal while mounting and connecting the unit.
Accessories 1. Receiver 1 pc 2. Remote controller 1 pc 3. Carrying case 1 pc 4. ISO connector 1 pc 5. Mounting parts: Hexagon nut M5 T (3.5 mm) 1 pc Mounting box (0.6 mm) 1 pc Left key (1.0 mm) 1 pc Right key (1.0 mm) 1 pc...
Installation/Connections First complete the electrical connections, and then check them for correctness. If you are not confident working with electrical wiring, removing and reinstalling interior panels, carpeting, dashboards or other components of your vehicle, please call your dealer in order to have the unit professionally installed. Before the installation 1.
Page 6
Installation method A WARNING: Disconnect negative battery terminal from battery before starting installation. Consult the vehicle’s owner’s manual for proper instructions. Remove two transport screws from the top of the unit before installation. 1. After removing the old unit and mounting sleeve, insert supplied mounting sleeve in the opening. 2.
Page 7
Installation method B Note: Outer trim frame, hook, and mounting sleeve are not used for this installation. This is only intended as a general guide; contact the vehicle's manufacturer for specific instructions. This method of installation uses the screw holes at the sides of the unit and the holes of the existing vehicle mounting bracket.
Page 8
Electrical connections Speaker Wiring Notes Follow the above wiring diagram to install the head unit with new or existing speakers. This unit is designed for use with four (4) speakers with the impedance between 4 Ohms to 8 Ohms. An impedance load of less than 4 Ohms could damage the unit.
Page 9
Never bridge or combine the speaker wire outputs. When not using four speakers, use electrical tape to tape the ends of the unused speaker outputs to prevent a short circuit. Never ground the negative speaker terminals to chassis ground. Using the ISO Connector 1.
Page 14
24. AUDIO button 25. Numeric pad 26. DISP/END CALL button 27. PHONE button Battery information of RC 1. Press the catch and at the same time pull out the battery tray. 2. Insert the 1 x lithium battery, type CR 2025 3V battery with the stamped (+) mark facing upward.
General operations Reset the unit Operating the unit for the first time or after replacing the car battery, you must reset the unit. Press RESET button to restore the unit to the original factory settings. Power button Press POWER button to turn on the unit. Press POWER to switch the power off. When you switch off the system or car ignition, the settings, tuner presets and the volume level will be retained in the unit’s memory.
Page 16
Keep pressing SEL button for 2 seconds to select the RDS function: TA SEEK/ALARM => RETUNE L/S => MASK DPI/ALL. TA (Traffic Announcement) mode To determine what action will the radio take if the newly tuned station does not receive TP (Transport Program) information for 5 seconds.
Page 17
To mask both PI and strong signal non-RDS station. Mute Press MUTE button to activate the Mute function. Press it again or use the VOL knob on the panel or press VOL+/VOL- buttons on the RC to cancel. Adjusting clock 1.
Radio operations Note: RDS (Radio Data System) service availability varies with areas. Please understand if RDS service is not available in you area, the following service is not available, either. Choose Radio Band Press BND/SYS button on the RC or BD/NP/SUB button on the panel to select a band. The unit has with five bands: FM1, FM2, FM3, MW1 (AM1) and MW2 (AM2).
Page 19
is being used. Save Your Preset Stations There are six numbered preset buttons, which can store and recall stations for each band. If while listening to a radio station you would like to save the station as a pre-set, press and hold one of the numeric buttons 1-6 until you hear a beep.
Page 20
Press 7/AF numeric button on the panel so that the unit will choose the strongest FM signal for the selected station, so that you do not have to re-tune the stations when driving between different transmitter coverage areas. When AF is on, it means RDS information is received; when AF is flashing, it means RDS information is not yet received.
Glossary PBC (PlayBack Control) PlayBack Control is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it can playback interactive software with the menu displayed on TV. And if the disc contains still images, it can playback high definition of still image.
DVD operations Insert/Eject disc Insert a disc into disc slot with label side up. The disc will be automatically loaded into the unit, even when it is off or in radio mode. The word “LOAD” will show on the display and the disc will play automatically. Press EJECT button to eject the disc from the slot.
Page 23
Panel Numeric Pad functions The number 1-6 buttons contain dual functions during disc play. After pressing SETUP button on the RC or 6/SET/PAU button on the panel, the setup menu will be prompted. Then the number buttons are for navigating and confirming the commands.
Page 24
Button 5: ENTER/Stop Press 5/ENTER/STOP button on the panel as the ENTER button on the RC for confirming the commands on the setup menu. Press and hold the button for 3 seconds to stop the disc. The unit will be idle until further command is given.
Page 25
Slow Motion Press SLOW button on the RC to perform slow motion of the video play. Slow motion speed within 1/2 up to 1/8 will be shown, according to the slowness. Cycle back to normal playback of press PLAY/PAUSE button to resume. Multi-Angle View Press ANGLE button on the RC to perform multi-angle playback.
Mixed-disc operations While you are playing mixed disc, which contains MP3, WMA, JPG or DivX formats, just insert the disc into the CD slot and the menu on the right hand side will be prompted. The unit will directly play the audio files. However, you can use the cursor buttons and ENTER button to select the format that you would like to view/listen to.
Page 27
Button 1-6 The functions of button 1-6 also apply to the mixed-disc play (See “DVD Operations” above). Return to the menu If you would like to go back to the playlist menu to choose the other file to view/listen to, press and hold button 5 to stop the playback.
VCD/CD/MP3 operations Insert/Eject CD Insert a disc into CD slot with label side up. The disc will be automatically loaded into the unit, even when it is off or at radio mode. The word “LOAD” will show on the display and the disc will play automatically. Press EJECT button to eject the disc from the slot.
Page 29
VCD: Press AUDIO button during playback. It is possible to switch the sound between mono and stereo sound. The sequence is as follows: Left Vocal --> Right Vocal --> Mono Left --> Mono Right --> Stereo CD: Press AUDIO during playback. It is possible to switch the sound between mono and stereo sound.
MP3 overview Notes on MP3 and WMA MP3 is short for MPEG Audio Layer 3 and refers to an audio compression technology standard. This product allows playback of MP3 files on CD-ROM, CD-R or CD-RW discs. The unit can read MP3 files written in the format compliant with ISO 9660. However it does not support the MP3 data written by the method of packet write.
Page 31
For ISO 9660 - compliant format, the maximum allowable depth of nested folders is 8, including the root directory (folder). When CD-R disc is used, playback is possible only for discs, which have been finalized. Make sure that when MP3 CD-R or CD-RW is burned that it is formatted as a data disc and NOT as an audio disc. You should not write non-MP3 files or unneeded folders along with MP3 files on the disc otherwise it takes a long time until the unit starts to play MP3 files.
AUX in, RCA out, SUB out, Video out and USB/SD operations Auxiliary Input The Auxiliary input jack is on the front of unit. Use the stereo jack wire and connect to the stereo plug of the unit. Route the other end of the wire to the any external audio device. Press and hold the MODE button to choose AUX in. Use VOL knob to adjust volume.
Menu operations (The screen on your player may have difference with the screen shown here). Press SETUP button on the RC or 6/SET/PAU button on the panel to display setup screen, use cursor LEFT/RIGHT and ENTER buttons to select the desired menu page: System, Language, Audio, Video, Digital.
Page 34
16:9: For 16:9 wide screen TV. Password: Original password is 0000. Rating: The rating of the disc is from 1 to 8: (1) with the most limits when playing. (8) with the least limits when playing. Original setting: 8 Note: The rating can be selected only under the password unlocked status, and the limits can be worked only under the password locked status.
Page 35
Audio setup Audio out: Select digital output format. SPDIF/OFF: There is no signal output from coaxial or optical output. SPDIF/RAW: When the unit is connected with the amplifier by coaxial or optical connecter, please select this mode. SPDIF/PCM: When the unit is connected with the two-channel digital stereo amplifier, please select this mode. Key: Setup the volume with the UP/DOWN cursor buttons.
Page 36
Digital setup Output mode: Select the output mode: LINE OUT: Compress the input signal. The volume is small. RF REMOD: The volume is large. Dynamic range: When you select the compressed mode as “line out”, select it to adjust the compression proportion and get the different compressed effect.
Bluetooth operations Pairing First, make sure the bluetooth function in your headset is set to “ON”. Then press and hold PHONE button until “PAIRING” blinks on the display waiting for the bluetooth device to connect. At this time, please run the bluetooth search and connect function in your cell phone.
Page 38
Incoming Call Display Anytime when there is an incoming call, the LCD display will show the incoming number. Answering call on the front panel When there is an incoming call, press ANSWER button to receive a call in your unit. You can perform this function on the front panel or on the RC.
Page 39
A2DP Stereo Transfer The function is for the cellphone, which is built-in with A2DP stereo transfer functions. Play the music in the cellphone, and then choose the option of “play via bluetooth” in the cellphone. The music from cell phone will be transfered to BT PLAY mode automatically.
Handling discs Dirty, scratched or warped discs may cause skip ping or noise. Handle the disc only by the edges. To keep clean do not touch its surface. Discs should be stored in their cases after use to avoid scratches. Do not expose discs to direct sunlight, high humidity, high temperature or dust.
Troubleshooting guide Symptom Cause Solution No power The car ignition is not on. If the power supply is properly connected to the car accessory switch the ignition key to “ACC”. The fuse is blown. Replace the fuse. Disc cannot be loaded. Presence of disc inside the player.
Specification General Power supply: 12V DC Fuse: 10 A and 1 A Maximum power output: 50W x 4 Dimensions (W x H x D): 178 x 51 x 178 mm ESP function 40 sec. for Audio-CD, 120 sec for MP3 FM stereo radio Frequency range: 87.5 –...
Page 43
S/N ratio (A-vtd)/Separation: 80dB/50dB Line out Output: 2 channels RCA line-out (2V) Bluetooth Bluetooth compatibility V 1.2/2.0 Specifications are subject to change without notice. Dimensions are approximate.
Page 44
................................44 ...........................45 .............................46 ...........................47 ............................52 ) .......................55 ............................57 ...............................60 ..........................63 ..........................64 ..................69 VCD/CD/ 3........................71 3................................73 AUX in, RCA, SUB out, USB/SD ...............75 ...............................77 Bluetooth ............................81 ............................84 ..............................85 ....................86 ..........................87...
Bluetooth PHONE, «PAIRING». bluetooth «BT car stereo». «0000» bluetooth; PHONE ANSWER, END CALL. bluetooth PHONE, ANSWER PHONE SEL, “DIS CONN”. SEL,...
Page 82
ANSWER, END CALL «Hang up». bluetooth bluetooth bluetooth ANSWER, Melody ( PHONE, SEL, MELODY 1. VOL, PHONE “MELODY”, SEL, «TEL» A2DP...
Page 87
10 A 1 A 178 x 51 x 178 mm ESP: CD/120 c 87.5 - 108.0 AM (MW) – 1620 DVD/SVCD/VCD/MP4/CDDA/MP3/WMA/HDCD/Picture-CD/ JPEG/MPEG4 DVD/DVD±R/±RW/CD/CD-R/CD-RW/USB/SD/MMC NTSC/PAL/NTSC/24 16:9 1,0 /75 - 20...
Page 88
RCA- (2 ) Bluetooth Bluetooth V 1.2/2.0...