Intel Motherboard Raptor AT Installation Manual page 43

EPP Version
1.7 and 1.9 (default) (available only for EPP mode).
Parallel Port IRQ
This option specifies the IRQ always used by the parallel port.
When the port is set to a fixed address the settings are (IRQ) 5
and (IRQ) 7 (default), otherwise it is set to Auto.
Parallel Port DMA Channel
This option is only available if the setting for the Parallel Port
Mode option is ECP. This option sets the DMA channel used by
the parallel port. When the port is set to a fixed address the
settings are DMA Channel 0, 1 and 3 (default), otherwise it is
set to Auto.
CPU Current Temperature
The current CPU temperature is shown (only available with the
optional hardware monitor).
CPU Overheat Warning
The setting is either Enabled or Disabled (default) (only
available with the optional hardware monitor).
CPU Overheat Warning Temperature
Sets the CPU Overheat Warning Temperature set point (only
available with the optional hardware monitor).
HW Monitor IN0 (CPU)
HW Monitor IN2 (+3.3V)
HW Monitor IN3 (+5V)
HW Monitor IN4 (+12V)
HW Monitor IN5 (-12V)
HW Monitor IN6 (-5V)
Chapter 2:BIOS Configuration
33