Table of Contents
Advertisement
Add and register a pendant
To register a pendant to your SN6127/SN6187 telephone base:
Press and hold /FIND HANDSET at the side of
.
the telephone base until the IN USE light turns
solid red.
2.
Put the pendant in the pendant charger. The
pendant status light flashes red and green to
indicate the registration is in progress. The pendant
beeps. Then it is registered with the telephone
base. It takes up to 60 seconds to complete
registration.
If registration fails, you hear an error tone.
Start again from Step above.
•
You cannot register a pendant if any other system device is in use.
•
If the pendant is not registered and you press
"Not registered."
Deregister all devices
If you want to replace a device, or reassign the designated handset
number of a registered handset, you must deregister all devices that are
registered to the telephone base. Then register each device individually.
To make deregistration easier, read all of the instructions on this and the
next page before you begin.
To deregister all devices from your SN1157/SN1197/SN6147/
SN6197 telephone base:
Press and hold FIND HS at the side of the
.
telephone base for about 0 seconds until the
telephone base shows Registering... Please
wait followed by Deregister all devices?, then
release FIND HS.
or VOICE, you will hear,
Advertisement
Table of Contents
