WingScapes Timelapse PlantCam User Manual page 11

After capturing, the LCD display shows for 10 sec (Fig. 4).
Then the camera return to STANDBY mode again. The red LED indicator
will flash every 3 sec to indicate that the camera is powered ON, but is
in a delay interval.
Moreover, the camera is STANDBY, press the Power/Status button to
switch on the LCD display for 10 sec (Fig.1), show the camera status. It
will not affect the delay interval unless the timer is within 15 seconds of
the next event. If the button is pressed within 15 seconds of the end of a
delay interval, the status will display and the interval will start over.
Memory Full
In the AUTO mode, if the LCD shows "MEM FULL!", it means that
the memory is full. The camera will shut down automatically. Please
clear the internal memory or insert an empty SD card.
Low Battery
In the AUTO mode, if the LCD shows "LOW BATTERY", it means
that the battery is low. The camera will shut down automatically.
Please replace the batteries.
Fig. 4
Four Modes
9