Four Modes - WingScapes Timelapse PlantCam User Manual

SETUP
Turn the Rotary Dial to the SETUP position to change timelapse
interval, convert photos to timelapse videos, and adjust other camera
settings. Also use SETUP position when connecting camera to computer
via USB cord. See detailed instructions for SETUP menu later in this
guide.
AUTO
In the AUTO mode, the camera takes photos or videos according to
the settings chosen in the SETUP menu. When the Rotary Mode Switch
is turned to AUTO, the camera status is displayed for 10 seconds, then
the first photo or video is captured, then the camera enters STANDBY
mode and the LCD display goes off, and begins counting down its
timelapse interval. The camera will wake up and counts down for 5 sec
(Fig. 2) when it is ready to record a picture or video. Note: for time lapse
interval 'ASAP', the camera will not go into STANDBY mode between
shots (approx. 3-4 second delay between shots). For time lapse interval
'30 seconds', the LCD display shows the status for 5 seconds only.
When a picture or video is recording the LCD will show "CAPTURING"
8

4. FOUR MODES

(change with Rotary Mode Switch)
Fig. 2
(Fig. 3).
Fig. 3