WingScapes Timelapse PlantCam User Manual page 18

Custom Settings & Converting Photos to Timelapse Video
DAILY SLEEP
Press + or – button to choose between 24 different settings: any hour
of the day from 1AM to MIDNIGHT. This determines the time each day
that the camera will go to sleep. (Note: There is no "BY LIGHT" option
to prevent inclement weather from temporarily turning off the camera in
the middle of the day.) Press the SELECT button to make selection. Press
the RIGHT (
Notes about DAILY WAKEUP & SLEEP
• If wakeup and sleep times are set to same setting (eg - 8am), the
timelapse program will run all 24 hours.
• If daily awake time is the same or shorter than the interval, camera
will take images only one time. (eg - WAKEUP: 8am and SLEEP:
11am so "awake" time is 3 hours. INTERVAL is set to 3 hour, 6
hour, or DAILY)
IMPRINT INFO?
Press + or - button to choose betweens YES and NO. Select YES to
imprint the time lapse interval, camera name, date and Time on the
bottom of your photos. Note: if YES is selected while camera is pro-
grammed to take VIDEO, the camera will take a photo with imprinted
info before each video clip. Press the SELECT button to make selection.
Press the RIGHT (
DATE/TIME
Press the SELECT button and the month will flash. Press + or – button
to select the proper month, then press the SELECT button again to
make selection. Repeat until date and time are set. Press the RIGHT
( ) button to choose next setting. Note: The default date is 01/01/99
12:00am.
16
) button to choose next setting.
) button to choose next setting.