System Status; System Test - Digital Monitoring Products XR2500F User Manual

System Status

Displays the internal system hardware current condition.
System Status shows the panel condition of AC power, battery
power, and optional panel tamper. When System Status is selected,
each monitor displays followed by OKAY or TRBL (Trouble) to
indicate the current condition.
Using the System Status Function
1. Access the User Menu.
2. Press COMMAND until SYSTEM STATUS? displays.
3. Press any Select key. The display starts listing each system
monitor and status.
For example: AC POWER - OKAY
Below are the System Monitor displays:
Keypad Display What it monitors
AC POWER AC power
BATTERY Battery power
TAMPER Panel box tamper
These are followed by either OKAY or TRBL (trouble).
If TRBL displays, call the service department for assistance.
4. The system then displays its firmware version (for example,
VER_201_3/08/04), the panel model (MODEL XR500N), and
then exits the User Menu.
System Setup

System Test

System Test is used to test the battery, alarm bell or siren, and
communication to a central station. The System Test function
begins automatically as soon as you select it.
Using the System Test Function
1. Access the User Menu.
2. Press COMMAND until SYSTEM TEST? displays.
3. The keypad displays SYSTEM PANICS. Press the Select key
below SYSTEM.
3. The System Test begins automatically and the keypad
displays the following messages in this order:
BELL SOUNDING during a two second bell test
1)
KEYPAD SOUNDING all keypads assigned to the same
2)
area sound their alarm tone for two (2) seconds during
the keypad sounder test
3) BATTERY - OKAY or BATTERY - TRBL to indicate the
battery condition
4)* TRANSMIT TEST and ATTEMPT NO: 1 during the transmit
test
TRANSMIT OKAY or TRANSMIT FAILED to show the
5)
results of the transmit test
TEST END to indicate the System Test is complete.
6)
7) You can press the Back Arrow key to end the transmit
test.
* The transmit test does not occur on local systems.
XR2500F User's Guide 11