Zone 2 Out Settings - Integra DTR-5.9 Instruction Manual

Zone 2—Continued
Input
Selector
Enter
Setup

Zone 2 Out Settings

If you've connected your Zone 2 speakers to an amp
with no volume control, set the Zone 2 Out setting, to
Variable so that you can set the zone's volume, balance,
and tone on the AV receiver.
1
Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "7. Hardware
Setup," and then press [Enter].
The Hardware Setup menu appears.
3
Zone2
Receiver
4
5
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
]/[ ]
Use the Up and Down [
buttons to select "2. Zone 2," and
then press [Enter].
The Zone 2 screen appears.
7–2. Zone2
Powered Zone2 Not Act
Zone2 Out Fixed
Use the Up and Down [
buttons to select "Zone 2 Out,"
and use the Left and Right
[ ]/[ ] buttons to select:
Fixed: The Zone 2 volume must be
set on the amp in that zone.
Variable: The Zone 2 volume can be
set on the AV receiver.
Press the [Setup] button.
Setup closes.
]/[ ]
]/[ ]
95