Integra DTR-5.9 Instruction Manual page 42

First Time Setup—Continued
- - - - - Speaker Detect Error - - - - -
FL
SL
SBL
C
Retry
Cancel
The right surround back speaker has been detected
but the left surround back speaker hasn't.
- - - - - Speaker Detect Error - - - - -
FL
SL
SBL
C
Retry
Cancel
There is a problem with a speaker. The speaker may
be broken or the subwoofer may be emitting sound
that is too high.
Retry
Cancel
The number of speakers detected on the second or
third measurement was different to the number
detected on the first measurement.
Make sure speakers that cannot be detected are con-
nected properly.
Retry: Return to step 2 and try again.
Cancel: Cancel the automatic speaker setup.
❏ Write Error
Retry
Cancel
This message appears if saving fails.
Try saving again. If this message appears after 2 or 3
attempts, the AV receiver is probably malfunctioning.
Contact the dealer.
Retry: Return to step 2 and try again.
Cancel: Cancel the automatic speaker setup.
42
Auto Speaker Setup
AUDYSSEY
: Yes FR : Yes
: --- : Yes
SR
: No SBR : Yes
: Yes SW : ---
Auto Speaker Setup
AUDYSSEY
: Error : Yes
FR
: Yes : Yes
SR
: Yes : Yes
SBR
: Yes : Yes
SW
Auto Speaker Setup
AUDYSSEY
Speaker Detect Error
Auto Speaker Setup
AUDYSSEY
Writing Error!
To Retry the Automatic Speaker Setup
Press the [Enter] button.
Make sure speakers that cannot be
detected are connected properly.
Changing the Speaker Settings Manually
If you wish to make changes to the settings found during
the automatic speaker setup, follow the directions on
pages 82–86.
Using a Powered Subwoofer
If you're using a powered subwoofer, as it outputs very
low-frequency sound and its position is usually low down,
it may not be detected by the automatic speaker setup. In
this case, increase the subwoofer's volume, select its
highest crossover frequency, and then try running the
automatic speaker setup again. Note that if the volume is
set too high and the sound distorts, it may not be detected,
so use an appropriate volume level. If the subwoofer has
a low-pass filter switch, set it to Off or Direct. Refer to
your subwoofer's instruction manual for details.