Operating Components Not Reached By The Remote Controller Signals (Ir In/Out); If The Remote Controller Signal Does Not Reach The Dtr-6.2 Remote Sensor; If The Remote Controller Signal Does Not Reach Other Components - Integra DTR-6.2 Instruction Manual

Operating components not reached by the
remote controller signals (IR IN/OUT)
The following equipment (sold separately) is essential for
operation:
• Onkyo's Multi-Room System kits (IR Remote Controller
Extension System), or
• Multiroom A/V distribution and control systems from Niles
®
and Xantech to name a few
If the remote controller signal does not reach the
DTR-6.2 remote sensor
If the DTR-6.2 is located inside a cabinet or other enclosure where
the infrared rays from the remote controller cannnot enter, then
operation with the remote controller will noe be possible. In such a
case, it will be necessary to install a remote sensor at a location
outside of the cabinet for the infrared rays from the controller to
reach.
With this connection, select "Main" for the Preference → IR IN
Setup → Position setting in the Setup menu (see page 42).
Connecting
block
IR IN
DTR-6.2
In the
cobinet
The IR IN input allows you to control the DTR-6.2 from the remote
zone (Zone 2) with the remote controller even though the remote
zone is physically separated. The diagram below shows how to make
the proper connections for the remote zone.
With this connection, select "Zone 2" for the Preference → IR IN
Setup → Position setting in the Setup menu (see page 42).
To IR IN
DTR-6.2
Connecting
block
Main room
20
IR Receiver
Remote Controller
: Signal flow
IR Receiver
Remote controller
Remote room
: Signal flow
Make connection as shown below. Do not plug the equipment into
the power source until the connection is complete.
®
Mini plug cable
If the remote controller signal does not reach
other components
In this situation, you will need to use a commercially available IR
emitter. Connect the mini plug of the IR emitter to the IR OUT
terminal on the DTR-6.2 and then place the IR emitter on the remote
sensor of the component or facing it. When the IR emitter is
connected, only the signal input to the IR IN terminal is output to the
IR OUT terminal. The signal input from the remote sensor on the
front of the DTR-6.2 will not be output to the IR OUT terminal.
IR IN
IR OUT
other
component
: Signal flow
IR
IN
Mini plug
OUT
DTR-6.2
from connecting block
IR
IN
OUT
DTR-6.2
IR Receiver
Connecting
block
DTR-6.2
IR Emitter
Remote Controller
: Signal flow
other component
Remote control
sensor
Emitter
Mini plug cable
IR Emitter