Operating Components Not Reached By The Remote Controller Signals (Ir In/Out) - Integra DTR-5.2 Instruction Manual

Operating components not reached by the
remote controller signals (IR IN/OUT)
The following equipment (sold separately) is essential for
operation:
• Onkyo's Multi-Room System kits (IR Remote Controller
Extension System), or
• Multiroom A/V distribution and control systems from Niles
®
and Xantech to name a few
• Xantech is a registered trademark of Xantech Corporation.
• Niles is a registered trademark of Niles Audio Corporation.
If the remote controller signal does not reach the
DTR-5.2 remote sensor
If the DTR-5.2 is located inside a cabinet or other enclosure where
the infrared rays from the remote controller cannnot enter, then
operation with the remote controller will noe be possible. In such a
case, it will be necessary to install a remote sensor at a location
outside of the cabinet for the infrared rays from the controller to
reach.
Connecting
block
IR IN
DTR-5.2
In the
cabinet
Make connection as shown below. Do not plug the equipment into
the power source until the connection is complete.
Mini plug cable
R
RS 232
DTR-5.2
IR Receiver
Remote Controller
: Signal folw
From the connecting block
IR
IN
OUT
If the remote controller signal does not reach
other components
In this situation, you will need to use a commercially available IR
emitter. Connect the IR emitter to the IR OUT terminal on the DTR-
®
5.2 and then place the IR emitter on the remote sensor of the
component or facing it. When the IR emitter is connected, only the
signal input to the IR IN terminal is output to the IR OUT terminal.
The signal input from the remote sensor on the front of the DTR-5.2
will not be output to the IR OUT terminal.
Connecting
block
IR IN
IR OUT
In the
cabinet
: Signal flow
DTR-5.2
R
IR
IN
RS 232
OUT
IR Receiver
DTR-5.2
IR Emitter
Remote Controller
other
component
: Signal flow
other component
Remote control
sensor
Mini plug cable
IR Emitter
15