Download Print this page

Frigidaire Vienna VWF-1 0305 Instructions & Operating Manual page 10

2 in 1 (wall mount & floor standing) color changing led fireplace
Hide thumbs


Place the front glass panel over the front of the fireplace aligning the slots in the brackets at
each side of the front panel with the knobs on the sides of the fireplace. Slot the front facade
down ensuring that the brackets are fully interlocked.
Instructions for Use
This fireplace can be operated either by the switches located on the top right hand side of the
fireplace or the supplied remote control.
Manual Operation
The switches are located on the top right hand side of the fireplace. The standby switch must
first be turned on.
Press the
button once to turn on the fireplace and flame effect. A red indicator light will
appear to indicate that the function is ON.
Press the
button for 3 seconds to operate the automatic color change function. The flame
colors will change every 10 seconds.
Press the 750W button once for low heat setting; press twice to turn off the heat.
Press the 1500W button once for high heat setting; press twice to turn off the heat.
Remote Control Operation
The power switch
fireplace will beep to indicate that it is powered up.
Insert 2 x 1.5V AAA batteries (not included) into the battery compartment of the remote control.
Make sure they are inserted with the correct polarity. (The -/+ signs placed in the proper
position.) Securely close the battery compartment cover.
It takes some time for the receiver to respond to the transmitter. Do not press any buttons on
the remote control more than once within two seconds in order for the fireplace to operate
located at the right hand side of the fireplace must first be switched on; the



  Related Manuals for Frigidaire Vienna VWF-1 0305

This manual is also suitable for:

Vienna vwf-1/0305