Problem Solving Guide; Check And Fault Messages In The Display - Miele T 8000 WP SUPERTRONIC Operating Instructions Manual

Problem solving guide

With the help of the following notes, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
,
Repair work to electrical appliances should only be carried out by a
suitably qualified person in strict accordance with current local and national
safety regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.

Check and fault messages in the display

Problem
You are asked to enter a
code.
Adjust the load
1
The programme
is cancelled, the
buzzer sounds.
Empty the
N
container
The programme
is cancelled, the
buzzer sounds.
Clean the door
:
filter
appears at the
end of a
programme.
Clean the plinth
:
filter which is
located in front of
the heat-exhanger
appears at the
end of a
programme.
42
Possible cause
Access via a code has
been activated.
This is not a fault.
In some programmes, if
the drum has been
underloaded or is empty,
the programme will be
cancelled. This can also
happen if the items are
already dry.
The condensed water
container is full or there is
a kink in the drain hose.
This is a reminder to
clean the fine filters in the
door and the door
opening under running
water.
This is a reminder to
clean the fine filter in front
of the heat exchanger
unit under running water.
Remedy
Enter the code (see
"Settings menu").
Use the Warm air
programme in future for
drying individual items.
– open the door, add
extra items and then
close the door again.
– Empty out the
condensed water
container or check the
drain hose.
– Switch the dryer off
and then on again.
– Clean the fine filters.
See "Cleaning and
care".
To delete the message:
– Select OK.