Miele T 8000 WP SUPERTRONIC Operating Instructions Manual page 46

Problem solving guide
Problem
There are humming
noises.
The display and the
sensors are not lit up
and the Start sensor is
flashing slowly.
The programme does
not start.
The display is in a
different language.
Power cut.
The interior drum
lighting does not
come on.
46
Possible cause
The compressor is
operating.
The display and sensor
illumination switches off
to save energy.
No obvious cause.
A different language
has been selected.
A programme which was running previously will
continue automatically when power is restored to the
tumble dryer as long as the Cooling down phase had
not been reached.
The lighting switches
off automatically (to
save energy).
Access via a code has
been activated.
Remedy
These noises are quite
normal and do not indicate a
fault.
– Touch the Start sensor.
The display and sensors
will light up.
– See "Settings, Display /
keypad illumination".
– Is the dryer switched on?
– Is the plug correctly
inserted into the socket
and switched on?
– Is the door closed
properly?
– Has the fuse or circuit
breaker tripped?
Set the language you want.
The flag symbol J will guide
you.
– Switch the dryer off and
then on again.
– If the lamp needs to be
replaced, follow the
instructions in "Changing
the lamp" at the end of this
section.
– When the code is entered
the lighting will come back
on.