Changing The Light Bulb - AEG SANTO 70312-1 KG Operating Instructions Manual

Malfunction
Unusual noises.
The compressor does not start
immediately after changing
the temperature setting.
Water on the floor or on sto-
rage shelves.

Changing the light bulb

Warning! There is a risk of electric shocks! Before changing the light bulb,
switch off the appliance and unplug it, or pull the fuse or the circuit breaker.
Light bulb data: 220-240 V
1. To switch off the appliance, turn the
temperature regulator to position "0".
2. Unplug the mains plug.
3. To change the light bulb press on the
rear hook and at the same time slide
the cover in the direction indicated
by the arrow.
4. Change the defective light bulb with
one of the some power (the maxi-
mum power is shown on the light
diffuser).
5. Replace the light cover by sliding it into
its original position.
6. Put the refrigerator back into opera-
tion.
20
Possible Cause
Appliance is not level.
The appliance is touching the
wall or other objects.
This is normal, no error has
occurred.
Water drain hole is blocked.
Remedy
Readjust the feet.
Move the appliance slightly.
The compressor starts after a
period of time.
See the "Cleaning and Care"
section.