Table of Contents
Advertisement
Malfunction
Large accumulation of
frost in the appliance,
perhaps also at the door
seal.
Unusual noises.
The compressor does not
start immediately after
changing the temperature
setting.
Changing the Light Bulb
Warning! Danger of electrical shock! Before replacing the light bulb
switch appliance off and remove the mains plug, or switch off or turn
out the circuit breaker or fuse.
Light bulb specifications: 220-240 V, max. 15 W, fitting: E 14
To switch the appliance off turn
the temperature regulator to
position "0".
Unplug the mains plug.
To change the light bulb, pull out
the screw "Y" and then remove the
protective cover "X".
Change the defective light bulb.
Refit the light bulb cover.
18
Possible cause
Door is not properly sealed
Appliance is not level.
Appliance is in contact
with wall or other objects.
A part at the back of the
appliance, e.g. a tube, is in
contact with another
appliance part or the wall.
This is normal, no error has
occurred.
Carefully warm the door
Remedy
seal with a hand-held hair
dryer at those points which
are not airtight (no warmer
than approx. 50°C). At the
same time, shape the war-
med door seal by hand, so
that it is again properly
seated.
Readjust the front levelling
feet.
Push appliance away a
short distance.
Please contact your Local
Service Force Centre
The compressor starts after
a period of time.
Advertisement
Table of Contents
