What to do if ...
Malfunction
Interior lighting does not
work.
Heavy build up of frost,
possibly also on the door
seal.
Unusual noises.
The compressor does not
start immediately after
changing the temperature
setting.
Water on the floor or on
storage shelves.
Changing the light bulb
Warning! There is a risk of electric shocks! Before changing the light
1
bulb, switch off the appliance and unplug it, or pull the fuse or the cir-
cuit breaker.
Light bulb data: 220-240 V, max. 15 W, fitting: E 14
0 To switch off the appliance, turn the temperature regulator to position
"0".
0 Unplug the mains plug.
48
Possible Cause
Light bulb is defective.
Door seal is not air tight
(possibly after changing
over the hinges).
Appliance is not level.
The appliance is touching
the wall or other objects.
A component, e.g. a pipe,
on the rear of the
appliance is touching
another part of the
appliance or the wall.
This is normal, no error has
occurred.
Water drain hole is blok-
ked.
Remedy
Please look in the "Chan-
ging the Light Bulb" sec-
tion.
Carefully warm the lea-
king sections of the door
seal with a hair dryer (not
hotter than approx. 50 °C).
At the same time shape the
warmed door seal by hand
such that it sits correctly.
Readjust the feet.
Move the appliance
slightly.
If necessary, carefully
bend the component out
of the way.
The compressor starts
after a period of time.
See the "Cleaning and
Care" section.