Vpn Tunnel Control; Activating A Vpn Tunnel - NETGEAR DG834G Reference Manual

VPN Tunnel Control

Activating a VPN Tunnel

There are three ways to activate a VPN tunnel:
• Use the VPN Status page.
• Activate the VPN tunnel by pinging the remote endpoint.
• Start using the VPN tunnel.
Note: Refer to
the IKE keepalive capability on an existing VPN tunnel.
Using the VPN Status Page to Activate a VPN Tunnel
To use the VPN Status screen to activate a VPN tunnel, perform the following steps:
1. Log in to the Modem Router.
2. Open the DG834G v3 management interface and click on VPN Status to get the VPN Status/
Log screen (Figure
Figure 8-29
Virtual Private Networking
Reference Manual for the ADSL Modem Wireless Router DG834G
"Using Auto Policy to Configure VPN Tunnels" on page 8-38
8-29).
v1.3, March 2007
to enable
8-29