NETGEAR DG834G Reference Manual page 148

Reference Manual for the ADSL Modem Wireless Router DG834G
3. Click on VPN Status
(Figure 8-30). Click on Connect for the VPN tunnel you want to activate.
Figure 8-30
Activate the VPN Tunnel by Pinging the Remote Endpoint
Note: This section uses 192.168.3.1 for an example remote endpoint LAN IP address.
To activate the VPN tunnel by pinging the remote endpoint (e.g., 192.168.3.1), do the following
steps depending on whether your configuration is client-to-gateway or gateway-to-gateway:
• Client-to-Gateway Configuration—to check the VPN Connection, you can initiate a request
from the remote PC to the DG834G v3's network by using the "Connect" option in the
NETGEAR ProSafe menu bar. The NETGEAR ProSafe client will report the results of the
attempt to connect. Since the remote PC has a dynamically assigned WAN IP address, it must
initiate the request.
To perform a ping test using our example, start from the remote PC:
a. Establish an Internet connection from the PC.
b. On the Windows taskbar, click the Start button, and then click Run.
c. Type
ping -t 192.168.3.1
8-30
(Figure 8-29) to get the Current VPN Tunnels (SAs) screen
and then click OK.
v1.3, March 2007
Virtual Private Networking