Configuration Summary (Telecommuter Example; Setting Up The Client-To-Gateway Vpn Configuration (Telecommuter Example - NETGEAR DG834G Reference Manual

Reference Manual for the ADSL Modem Wireless Router DG834G

Configuration Summary (Telecommuter Example)

The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Assure that there are no firewall restrictions.
Table 0-3. Configuration summary (telecommuter example)
VPN Consortium Scenario:
Type of VPN:
Security Scheme:
IP Addressing:
Gateway
Client
192.168.0.1/24
Telecommuter Example
LAN IP
192.168.0.1
Router
(at employer's
main office)
Figure B-12
Setting Up the Client-to-Gateway VPN Configuration
(Telecommuter Example)
Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway involves the following two steps:
• Step 1: Configuring the Client-to-Gateway VPN Tunnel on the VPN Router at the Employer's
Main Office.
B-14
Scenario 1
PC/client-to-gateway, with client behind NAT router
IKE with Preshared Secret/Key (not Certificate-based)
Fully Qualified Domain Name (FQDN)
Dynamic
Gateway A
WAN IP
FQDN
ntgr.dyndns.org
"fromDG834G.com"
v1.3, March 2007
NAT Router B
WAN IP
0.0.0.0
"toDG834G.com"
Router
(at telecommuter's
home office)
NETGEAR VPN Configuration
Client B
192.168.2.3
PC
(running NETGEAR
ProSafe VPN Client)