Vpn Tunnel Control; Activating A Vpn Tunnel - NETGEAR DG834Gv3 - 54 Mbps Wireless ADSL Firewall Modem Reference Manual
Adsl modem wireless router
Hide thumbs
Also See for DG834Gv3 - 54 Mbps Wireless ADSL Firewall Modem:
- Setup manual (32 pages) ,
- Configuration manual (7 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
VPN Tunnel Control
Activating a VPN Tunnel
There are three ways to activate a VPN tunnel:
•
Use the VPN Status page.
•
Activate the VPN tunnel by pinging the remote endpoint.
•
Start using the VPN tunnel.
Note: Refer to
the IKE keepalive capability on an existing VPN tunnel.
Using the VPN Status Page to Activate a VPN Tunnel
To use the VPN Status screen to activate a VPN tunnel, perform the following steps:
1. Log in to the Modem Router.
2. Open the DG834G v3 management interface and click on VPN Status to get the VPN Status/
Log screen
(Figure
Figure 7-29
Virtual Private Networking
Reference Manual for the ADSL Modem Wireless Router DG834G
"Using Auto Policy to Configure VPN Tunnels" on page 7-38
7-29).
v1.0, January 2006
to enable
7-29
Advertisement
Table of Contents
Troubleshooting
