Stirrer Assembly - GE Advantium PSA1200R Technical Service Manual

Stirrer Assembly

The Stirrer Assembly consists of a motor, blade,
and cover. The blade is motor-driven and rotates
on a pin embedded in the stirrer cover. The Stirrer
Assembly is located at the top of the oven cavity.
To remove the stirrer blade:
Note: It is not necessary to remove the stirrer motor
when removing the stirrer blade.
1. Disconnect power from the microwave oven and
open the door.
2. Remove the 2 Phillips-head screws that attach
the cover to the oven cavity.
3. Lower the left side of the cover approximately
1 inch, then slide it to the left and remove the
cover from 2 tabs located on the right.
Stirrer Cover
4. Lift the stirrer blade off the pin embedded in the
cover.
The stirrer motor has an approximate resistance
value of 120 .
To remove the stirrer motor:
Note: It is not necessary to remove the stirrer blade
when removing the stirrer motor.
1. Remove the Air Tunnel Cover. (See
2. Disconnect the stirrer motor wire harness.
3. Remove the 2 Phillips-head screws that attach
4. Lift the left-side of the stirrer motor, then remove
Tab
Tab
Caution: When installing the stirrer motor,
misalignment of the stirrer blade hub can damage
the stirrer cover. Before installing the stirrer motor,
use a screwdriver inserted into the stirrer blade hub
to pre-align the square drive of the stirrer blade to
allow engagement of the motor shaft.
Blade
– 60 –
.)
Cover
the stirrer motor to the top of the oven.
it from the oven.
Stirrer Motor
Stirrer Blade Hub
Air Tunnel
Disconnect