Door Assembly - GE SpaceMakerXL JMV1420 Technical Service Manual

DOOR ASSEMBLY

The door assembly will be available as a complete
TOP HINGE
BOTTOM HINGE
assembly with handle. The handle will also be available
as a separate part as will the rest of the door as seen in
BOTTOM HINGE
TOP HINGE
the door breakdown.
To Adjust Door:
HINGE SCREWS
HINGE SCREWS
(Alignment with control panel)
DOOR
1. Remove top grille - 2 screws.
DOOR
2. Remove bottom panel - 3 screws at front.
3. Loosen top and bottom 5/16" hinge screws. The screw
holes are slotted to allow for minimal movement. Align door
DOOR
DOOR
and tighten screws.
5. Check interlocks and monitor for proper operation. Check
door for microwave leakage with approved meter.
HINGE SCREWS HINGE SCREWS
To Remove Door:
1. Remove power, top grille and short out capacitor
2. Remove the 4 (2 on top & 2 on bottom) 5/16" head screws
on door hinges and #2 phillips head screw on top.
3. Door will pull away from unit with the hinges attached to
the door.
4. When reinstalling door reverse procedure and a
to the control panel before securing door hinge screws.
NOTE: Door on a microwave oven is designed to act as
an electronic seal preventing the leakage of microwave
energy from oven cavity during cook cycle. This
function does not require that door be airtight, moisture
(condensation) tight or light-tight. Therefore, occa-
sional appearance of moisture, light or sensing of
gentle warm air movement around oven door is not
abnormal an do not of themselves, indicate a leakage of
microwave energy from oven cavity. If such were the
case, the oven could not be equipped with a vent, the
very purpose of which is to exhaust vapor-laden air
from oven cavity.
To Remove Door Handle:
With door open:
HANDLE
1. Remove inner door trim.
AVAILABLE
2. Remove door handle screws.
AS A
SEPARATE PART
19