Cooktop Components; Appearance Defects; Cooktop Removal From Countertop - GE Profile PHP900 Technical Service Manual

WARNING: Before servicing the cooktop, power
must be removed from the cooktop by turning the
power off at the circuit breaker.
WARNING: Sharp edges may be exposed when
servicing. Use caution to avoid injury. Wear Kevlar
gloves or equivalent protection.
Note: When servicing the cooktop, care must be
taken not to scratch or damage the glass.
• All components are accessible by removing the
glass top.
• If the display/touch board is damaged, it can
be replaced as a unit by removing the glass top
and replacing the touch board. The touch board
is located by pins and springs/foam tape on the
back side of the board.
• If the power or fi lter boards are damaged, they
can be replaced by removing the glass top,
removing the elements, removing the touch
board, and removing the aluminum heat shield
and insulation. This will allow access to the
electronics assemblies, and the board can be
removed and replaced.

Appearance Defects

Scratches, marks, discoloration, stains, spots, etc.
can be caused by food, cookware, utensils, cleaning
solutions, or water. Before replacing the cooktop,
use the cooktop cleaning procedure outlined in the
Owner's Manual.

Cooktop Components

Cooktop Removal From Countertop

To remove the cooktop from the countertop:
Caution: The hold-down brackets, heat baffl e (if
installed), and screws on the bottom of the burner
box can damage the countertop surface. Use care
to protect the countertop appearance.
1.
2.
3.
Inner Screw
– 21 –
Open the cabinet door and remove each of the
2 thumbscrews that secure the cooktop to the
bottom of the countertop.
Remove the outer hex-head screw from each
hold-down bracket.
Loosen the inner hex-head screw from each
hold-down bracket.
Cooktop
Cooktop
Bracket
Outer Screw
Countertop
Countertop
Thumbscrew
(Continued next page)