Diagrams; Ic Block Diagram - Sony XM-D1000P5 Service Manual

SECTION 3

DIAGRAMS

THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS
AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is
printed in each block.)
for schematic diagram:
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
1
• All resistors are in Ω and / W or less unless otherwise
4
specified.
• % : indicates tolerance.
• 2 : nonflammable resistor.
Note: Note:
The components identi- Les composants identifiés par
une marque 0 sont critiques
fied by mark 0 or dotted
line with mark 0 are criti- pour la sécurité.
cal for safety. Ne les remplacer que par une
Replace only with part piéce por tant le numéro
number specified. spécifié.
• A : B+ Line.
• B : B– Line.
• Total current is measured with no-signal condition.
• Power voltage is dc 14.4V and fed with regulated dc power
supply from +12V and REM terminals.
• Voltage is dc with respect to ground under no-signal
condition.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: AUDIO
for printed wiring boards:
Note:
• X : parts extracted from the component side.
• : Pattern from the side which enables seeing.
(The other layer's patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from the
(Side B) pattern face are indicated.
Parts face side: Parts on the parts face side seen from the
(Side A) parts face are indicated.

3-1. IC BLOCK DIAGRAM

IC6 TL494CN
16 15 14 13 12 11 10 9
ERROR REF 5V
0.1V
OSC
ERROR
1 2 3 4 5 6 7 8
9 9
XM-D1000P5