Table of Contents
Advertisement
7. Place the remaining type "A" coal
between the front and rear base coals.
The letter "A" should be upside down
with its rear face between the right
and centre coals of the rear base coal.
Angle the coal so that the gap
between it and the type "B" coal to its
right is appreciably larger than the
gap between it and the type "A" coal
to its left but do not have it touching the type "A" coal. This will give the best flame
effect. See figure 10.
Regular maintenance
In order to achieve and maintain high levels of personal safety and performance
efficiency, it is essential that the opening at the back of the fire and the flue are kept
clear of any form of obstruction. It is possible that deposits of mortar or soot could fall
and accumulate causing the flue to be blocked or restricted and so preventing proper
clearance of dangerous exhaust fumes.
In the United Kingdom it is the law that a landlord must have any gas appliance, flue
and pipework which is situated in a tenant's premises checked for safety at least every
twelve months by a competent person (In the U.K, a CORGI registered installer).
We recommend that all gas appliances and their flues, wherever situated, are checked
annually.
Servicing
In the United Kingdom servicing can be carried out either by a Valor service
!
engineer or a CORGI registered installer.
If you require your fire to be serviced, please contact Valor Service on 08706 090
!
081 and quote the following details;
Model name and number.
Appliance serial no. (To be found on the plate close to the control knob.)
If you wish to replace any of the owner replaceable parts listed below, spare parts
!
are available nationwide via the 'interpart stockist network'. For your local
stockist consult Yellow pages under Central Heating.
When ordering please quote the part number shown below.
OWNER GUIDE
Figure 10.
MAINTENANCE
Pa ge 1 2
Advertisement
Table of Contents
