Water Valve Assembly - GE Profile Harmony WPGT9360 Technical Service Manual

Water Valve Assembly

The water valve consists of a valve body and 5
solenoid coils. It is only available as a complete
assembly. Each solenoid controls a specifi c water
function.
Water Valve Assembly
Softener
Cold Water
Bleach
• Each coil on the water valve assembly has an
approximate resistance value of 30 Ω.
• The water valves receive power from the
inverter. They are connected to the 6-pin blue
connector on the inverter board. (See Inverter
and Main Board Pin Connectors.)
• When energized, there should be approximately
13 VDC at the appropriate coil.
AX WX AX WX PX
Bleach CV HV
Softener
Additive
10 4 9 3 8 2 7 6 1
5
BX YX NX
NX
S X B X
Y X
C X OX
N X
2
4 3 5 6 1
N X
I nv e r t e r
To remove the water valve assembly:
1. Remove the
Backsplash
2. Remove the 3 Phillips-head screws that hold the
protective cover in place.
Water Distribution Pipe
Additive Hot Water
COLOR CODE
LETTERS COLOR LETTERS COLOR
AX LT. BLUE RX RED
BX BLACK SX GRAY
CX BROWN GX GREEN
NX
DK.BLUE VX PURPLE
OX WX
ORANGE WHITE
PX PINK YX YELLOW
THE "X' INDICATES ONE SOLID COLOR-
NO TRACER. WIRES WITH TRACER SHOW
BOTH COLORS, EXAMPLE - WR IS WHITE
WITH RED TRACER.
.
– 28 –
3. Note the placement of the wires, then
disconnect the wiring to the solenoid coils.
Disconnect
4. Remove the 2 water inlet hoses:
a. Squeeze each clamp and slide it back.
b. Carefully break the hoses loose.
c. Remove the hoses.
Clamps
Inlet Hoses
5. Remove the 3 Phillips-head screws that hold the
water valve assembly in place and the 2 Phillips-
head screws that hold the water distribution
pipe in place.
6. Remove the water valve assembly and
distribution pipe.
Note: The distribution pipe separates from the water
valve assembly as shown below.