Water Valve Assembly
The water valve consists of a valve body and five
solenoid coils. It is only available as a complete
assembly. Each solenoid controls a specific water
function.
•
Each coil on the water valve assembly has an
approximate resistance value of 30 Ω.
•
The water valves receive power from the
inverter. They are connected to the 6-pin
blue connector on the inverter board. (See
Inverter and Main Board Pin Connectors.)
•
When energized, there should be
approximately 13-VDC at the appropriate coil.
3. Note the placement of the wires, then
disconnect the wiring to the solenoid coils.
4. Remove the 2 water inlet hoses:
a. Squeeze each clamp and slide it back.
b. Carefully break the hoses loose.
c. Remove the hoses.
5. Remove the 3 Phillips head screws that hold
the water valve assembly in place and the
2 Phillips head screws that hold the water
distribution pipe in place.
– 27 –