Overview; Switching The Washer And Dryer Backsplashes - GE Profile Harmony WPGT9360 Technical Service Manual

Switching the Washer and Dryer Backsplashes

Overview

When viewed from the front, the washer is shipped
for installation on the left and the dryer is shipped
for installation on the right. If the hose utility
connections are arranged so that the units must
be installed with the washer on the right and the
dryer on the left, the backsplashes of the washer
and dryer can be switched in order to maintain the
proper curved appearance.
Tools Needed
#2 Phillips-head
Screwdriver
WARNING!
• Make sure the washer and dryer are unplugged.
• Turn both the home hot and cold-water valves
to the off position.
• Turn the home gas shut-off valve to the OFF
position (for gas dryer models).
To switch the washer and dryer backsplashes:
1. Place a towel over the lid of the washer to
2. Remove the 2 Phillips-head screws from the
3. Rotate backsplash forward and lift off.
4. Remove the 2 Phillips-head screws holding
Rear Cover
Towel (2)
– 58 –
prevent scratches to the surface.
washer backsplash.
Screw
Rear of Washer
the backsplash to the rear cover. Remove the
backspash from the rear cover.
Screws
Screw