Top Cover
The top cover is held in place by 2 Phillips-head
screws (located on the top, back of the washer) and
two front tabs.
To remove the top cover:
1. Remove the 2 Phillips-head screws that hold the
top cover in place.
2. Remove the 4 Phillips-head screws (2 on each
side) that hold the back cover in place. Remove
the back cover.
3. Disconnect the pressure sensor hose from the
outer tub.
Disconnect
4. The main wiring harness is held in place by
plastic clips on the inside corner of the washer
cavity. Remove the wiring harness from the
holding clips.
5. Remove the Phillips-head screw that holds the
ground wire to the upper back cover.
6. Disconnect the four wiring harness connectors.
7. Lift the back of the top cover and slide it forward
to clear the front tabs. Remove the top cover.
– 29 –