GE Profile Harmony WPGT9360 Technical Service Manual page 59

5. Disconnect the ribbon at the right of the washer
control board by pulling the connector at the
end of the ribbon off the metal pins.
Note: Do not disconnect any other wires from
the washer control board.
Rear of Washer
6. Remove the 4 Phillips-head screws holding the
washer control board to the backsplash, then
remove the control board and set it aside.
Screws
7. Place a towel over the top surface of the dryer
to prevent scratches to the surface.
8. Remove the 4 Phillips-head screws from the
dryer backsplash. Rotate backsplash forward
and lift off.
Screws
Rear of Drye r
9. Disconnect the ribbon at the right of the dryer
control board by pulling the connector at the
end of the ribbon off the metal pins.
Note: Do not disconnect any other wires from
the dryer control board.
10. Remove the 4 Phillips-head screws holding the
dryer control board to the backsplash.
11. Remove the dryer control board and set it aside.
Screws
– 59 –
Rear of Dryer
Screws
(Continued Next Page)