GE Profile Harmony WPGT9360 Technical Service Manual page 13

Summary Screen
The Wash Options allow you to set options for the
About the
current wash cycle only. After you have made all
Wash Options
desired changes, press OK.
Delay Start – Use to delay the start of your washer.
Press DELAY START to change the delay time.
*
Presoak – Soaks the clothes before beginning the
wash cycle. Press PRESOAK to change the soaking
time.
Additives – Appears ONLY AFTER a presoak has
been selected. Uses the contents of the Pretreat
dispenser tray for a presoak. When selected, the
washer will drain after the presoak and fill again for
the wash cycle. Press ADDITIVES to specify if you
will NOT be using a Pretreat additive or if you do
not want the washer to drain after presoak.
Extra Rinse – Adds an additional cold rinse to the
end of the wash cycle.
Signal – Alerts you that the cycle is complete. The
clothes should be removed when the beeper goes
off so wrinkles won't set in. Touch SIGNAL to
select the volume or to turn the beeper off. The
new volume will be saved as the default setting.
Extended Spin – Increases the length of the spin
time to extract more water from your clothes.
NOTE: The water level will vary depending on the
load size and type. The washer uses adaptive filling
and load sensing to provide the appropriate water
level for effective and efficient wash performance
and energy usage.
NOTE: Water may not cover the top level of the
clothes. This is normal for high efficiency washers.
The water fill is optimized by the system for better
wash performance.
You can adjust the length of the wash cycle by
Adjusting the
changing the cycle time, adding a Delay Start
Time Settings
or adding an Extending Spin.
Cycle Time – Press CYCLE TIME; then use
the arrows to select more or less time.
Delay Time – Use to add a Delay Start to the
beginning of the wash cycle. Press DELAY
TIME; then set the DELAY START time in the
OPTIONS menu.
Extended Spin – Increases the length of the spin
time to extract more water from your clothes. Press
EXTENDED SPIN; then select EXTENDED SPIN
from the OPTIONS menu.
NOTE: After the wash cycle begins, you will not
be able to change the Cycle Time or Delay Time.
The washer will beep twice if you try to change
the times after the cycle begins.
OPTIONS
DELAY
START
PRE
SOAK
ADDITIVES
*Note: The Pre-Soak cycle can be set for 15
minutes, 30 minutes, 45 minutes, and 1 to 8
hours. To advance the pre-soak time, press
the PRE-SOAK key until the desired time is
reached. After the washer fills, it agitates
for 5 minutes. After 5 minutes it stops and
soaks for the set pre-soak time. After the pre-
soak times out, the washer drains and spins,
then refills for the remaining wash cycle.
ADJUST TIME SETTINGS
CYCLE TIME
– 13 –
OK
EXTENDED
1
HR
SPIN
EXTRA
15
MIN
RINSE
SIGNAL
ARE YOU USING
PRESOAK ADDITIVES ?
NO
YES
DELAY TIME
EXTENDED SPIN