Makita CC01 Instruction Manual page 7

Switch action
1
2
012362
CAUTION:
Before installing the battery cartridge into the tool,
•
always check to see that the switch trigger
actuates properly and returns to the "OFF" position
when released.
Do not pull the switch trigger hard without pressing
•
the lock-off lever. This can cause switch breakage.
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided. To start the tool, slide
the lock-off lever and pull the switch trigger. Release the
switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing diamond wheel
3
2
4
012356
CAUTION:
When installing the diamond wheel, be sure to
•
tighten the bolt securely.
Use only the Makita wrench to install or remove the
•
diamond wheel.
To remove the diamond wheel, press the shaft lock fully
so that the diamond wheel cannot revolve and use the
wrench to loosen the hex bolt counterclockwise. Then
remove the hex bolt, outer flange and diamond wheel.
1. Lock-off lever
2. Switch trigger
1. Shaft lock
2. Hex wrench
1
3. Tighten
4. Loosen
1
2
3
4
012357
To install the diamond wheel, follow the removal
procedure in reverse. Always install the diamond wheel
so that the arrow on the diamond wheel points in the
same direction as the arrow on the diamond wheel case.
BE SURE TO TIGHTEN THE HEX BOLT SECURELY.
1
2
012438
NOTE:
If a inner flange is removed by chance, install the
•
inner flange so that its protrusion (bigger side)
faces inside as shown in the figure.
Hex wrench storage
012358
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Installing water supply
3
012365
7
1. Inner flange
2. Diamond wheel
3. Outer flange
4. Hex bolt
1. Hex bolt
4
2. Outer flange
3. Diamond wheel
4. Inner flange
5. Protrusion
(bigger side)
5
3
1. Hex wrench
1
2
1. Tank holder
2. ScrewA
1
3. Notch
4. Motor housing
4