2F8/2F9/2GA
1-2-3
Installing the expanding memory (optional)
<Procedure>
1. Power off the printer and unplug the printer
power cord.
2. Open the right side cover.
3. Remove the screw and open the inner
cover.
4. Push out the clamps on both ends of the
memory socket.
5. Remove the memory from its package.
Aligning the cutouts of the memory with the
matching keys of the socket, carefully plug
the memory into the memory socket until it
clicks in place.
6. Push the two socket clamps to secure the
memory.
7. Close and secure the inner cover by one
screw.
8. Close the right side cover.
Testing the expanded memory
1. To verify that the memory is working prop-
erly, test it by printing a status page (refer to
Printing a status page on page 2-15).
1-2-12
Screw
Figure 1-2-15
Memory
socekt
Clamp
Clamp
Cutout
Cutout
Figure 1-2-16
Right side cover
Inner cover
Memory