Installing Expansion Memory (Optional For 16/18 Ppm Printers) - Kyocera FS-720 Service Manual

2GL/2FV/2FW

1-3-2 Installing expansion memory (optional for 16/18 ppm printers)

<Procedure>
1. Turn off printer power.
* Caution: Do not insert or remove expansion
memory while printer power is on.
Doing so may cause damage to the printer
and the expansion memory.
2. Open the top cover.
3. Remove the right side cover.
4. Open the stoppers of the memory socket on
the main PWB.
5. Insert the memory so that the two notches of
the memory are engaged with the projec-
tions of the memory socket.
6. Close the stoppers of the memory socket.
7. Refit the right side cover.
8. Print a status page to check the memory
expansion. See page 1-4-3.
* If memory expansion has been properly per-
formed, information on the installed memory
is printed with the total memory capacity has
been increased. Standard memory capacity
16 MB (16 ppm printer), 32 MB (18 ppm
printer).
1-3-6
Memory socket
Stopper
Main
PWB
Top cover
Figure 1-3-8
Memory
(DIMM)
Stopper
Right side cover