Table of Contents
Advertisement
Door Shell Installation
1. Remove the door retainer shipping latch following the directions below.
Standard
Screwdriver
Rotate this shaft
1/4 turn clockwise
until the door
unlatches.
2. Place the door shell face down on a non-scratching surface.
3. Remove and discard the two set screws pre-installed on the bottom of the door shell (if applicable).
1/8" Hex Wrench
© Travis Industries
Optional Equipment
Swing the door retianer open. Remove and
discard the shipping latch and nut.
Shipping Latch
100-01332
Door Retainer
9/16" Wrench
4121214
37
Advertisement
Table of Contents
