Planning The Installation; Preparation For Installation; Additional Accessories Needed For Installation; Installation Considerations - Travis Industries Lopi Answer Owner's Manual

18 Fireplace Insert Installation
SAFETY NOTICE:
Please read this entire manual before you install and use your new room heater. Failure to
follow instructions may result in property damage, bodily injury, or even death. Contact
local building or fire officials about restrictions and installation inspection requirements in
your area.

Planning The Installation

We suggest that you have an authorized Travis Industries dealer install your fireplace insert. If you
install the fireplace insert yourself, your authorized dealer should review your installation plans.
Check with local building officials for any permits required for installation of this fireplace insert and
notify your insurance company before proceeding with installation.

Preparation for Installation


Check for damage to the exterior of the fireplace insert (dents should be reported, scratches can be
fixed by applying touch up paint).

Check the interior of the firebox (replace cracked firebrick and make sure baffle is in place).
The fireplace insert can be lightened by removing the firebricks and baffle (pg 33) - replace before
operation.

Additional Accessories Needed for Installation


Legs or Pedestal

Door Shell
Small Black
Small Brass
Small Pewter

Installation Considerations

Installation Type
Insert with Positive Flue (Full Reline)
(Page 22)
Insert with Direct Connect Flue
(Page 22)

Packing List


Wood Moisture Meter
© Travis Industries
Old Part # (includes ashlip trim)
99300195
99300196
99300199
100-01332
(for qualified installers only)
New Part # (no ashlip trim)
96100634
96100635
96100636
Considerations
• Utilizes existing masonry or zero clearance fireplace
• Provides best draft
• Easiest to clean
• Utilizes existing masonry or zero clearance fireplace
• Provides good draft
• Requires fireplace block-off plate
4121214