Operation; Before You Begin; Location Of Controls; Starting The Pilot Flame - Travis Industries 864TRV Owner's Manual

6

Before You Begin

•
Read this entire manual before you use your new fireplace (especially the section "Safety
Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage,
bodily injury, or even death.

Location of Controls

Optional Blower Control
Optional Accent Light
Pilot Igniter
On/Off Switch
Gas Control Knob
Flame Adjust Knob
Comfort Control
Optional Blower Control This knob controls the speed of the optional internal convection blower
Optional Accent Light
© Travis Industries

Operation

Comfort Control
Lift the control cover up and swing it
forward to access the controls.
The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark
directly next to the pilot, igniting the pilot flame.
This control is used to turn the fireplace burners on and off.
This knob is used to control gas to the fireplace and for starting the pilot.
There are three positions, ON, OFF, & PILOT. The pointer to the left of
the knob indicates the position this knob is in.
This knob controls the flame height from low ("LO") to high ("HI"). The
pointer above the knob points to the position this knob is in.
This lever turns the rear burner on and off.
NOTE: THIS IS NOT A SHUTOFF VALVE.
that pushes heated air into the room.
This knob controls the optional accent lights located behind the logs.
4050812
Pilot Igniter
ON/OFF Switch
Gas Control Valve
Flame Adjust Knob
An instruction card for operating
the fireplace is attached to the
inside of the fireplace here.
Replace it for easy reference.
The Pilot Flame can be
found under the right side log
.
Gas Control Knob
100-01168_001