Assembly - Hitachi C 10RA Technical Data And Service Manual

8-2. Assembly

WARNING: To avoid an accident or personal injury, always confirm that the switch is turned OFF and
the power plug has been disconnected from the receptacle before assembly of this tool.
8-2-1. Assembly of the Handle
Wheel
Handle
8-2-3. Assembly of the Rip Fence (Fence Ass'y)
Clamp
handle (A)
8-2-3. Assembly of the Miter Gauge
Groove
Sheet bar
Miter gauge
Fig. 7
Rip fence
Groove
Fig. 8
Fig. 9
The handle allows faster turning of the wheel.
When properly assembled, it will rotate freely but with only a
small amount of play,
(1) Tighten the screw of the handle until it hits against the
wheel.
(2) Securely tighten the handle nut with a wrench.
The rip fence can be conveniently used to cut a workpiece
into different pieces of precise width or into parallel pieces.
It can be mounted on either the right or left side of the table.
(1) Align the groove in the front of the table with the groove
in the fence bracket and slide it in the direction indicated
by the arrow from the end of the table.
(2) Attach clamp handle (A) to the screw of the fence
bracket.
(3) When moving the rip fence, loosen clamp handle (A) to
release the lock. To lock the rip fence, tighten clamp
handle (A).
The miter gauge is convenient for cutting long or angular
pieces which are difficult to work on with the rip fence. It
can be mounted on either the right or left side of the table.
Align the sheet bar of miter gauge with the table groove and
slide it in the direction indicated by the arrow through the
front of the table.
--- 10 ---