Step 4: Connect The Monitor; Step 5: Connect The Power Adapter And Power On The Dvr; Step 6: Upgrade Firmware To Latest Version (If Available) - Lorex DV700 Series Instruction Manual

6 Basic Setup (DV700 Series)

6.4 Step 4: Connect the Monitor

• Connect the included HDMI cable from the HDMI port to the TV or monitor
(recommended).
OR
• Connect a VGA cable (not included) from the VGA port to the monitor.
1. VGA port.
2. HDMI port.

6.5 Step 5: Connect the Power Adapter and Power on the DVR

1. Connect the included power adapter to the DC 12V port. Connect the end of the power
adapter to a wall socket or a surge protector.
2. Turn the power switch to ON to turn on the DVR.
At startup, the system performs a basic system check and runs an initial loading sequence.
After a few moments, the system loads a live display view.

6.6 Step 6: Upgrade Firmware to Latest Version (if Available)

If a firmware upgrade is available, you will be asked to install it once the system starts up.
It is required to upgrade your system firmware and client software or mobile apps to the lat-
est version to enable remote connection to the system.
If a firmware upgrade is available:
1. After startup, a notification will appear asking you to upgrade the firmware. Click OK to
upgrade.
#LX400060; r.30328/30328; en-US
10