Pip/Pop/Split Source - Zenith D60WLCD Installation And Operating Manual, Warranty

PIP/POP/SPLIT Sources
PIP (Picture-in-Picture) / POP (Picture-out-of-
Picture) / SPLIT modes let you watch main and
sub pictures at the same time.
PIP/POP/SPLIT modes turn off in instances indi-
cated below.
• Changing main source
• Changing Aspect Ratio
• Activating Channel Add/Del/Surf, Channel
Label or Channel Block in Setup menu
• Activating Help menu
Press the PIP button on the remote con-
1
trol to activate PIP (Picture in Picture)
mode.
Press the LEFT/RIGHT arrow to select
2
CH+/-, Swap, Source or Move.
• CH+/- : Use the UP/DOWN arrow to
select a program for the sub picture.
Changing programs on the sub picture
is only possible if the PIP signal
source is NTSC RF signal.
If you want to change the program
on the main picture, press ch +/-
button.
• Swap : Use the UP/DOWN arrow to
swap main and sub picture.
• Source : Use the UP/DOWN arrow to
select a source for sub picture.
Your choices are : TV, Video1/2,
Front, Component 1/2.
RGB-HD/STB and RGB-PC input sources
cannot used as PIP screen source.
• Move : Use the UP/DOWN arrow to
move the sub picture on the screen.
Press the EXIT button to exit PIP mode
3
or press the PIP button again to acti-
vate POP mode.
P A G E 2 4
vcr cable dvd sat
tv
mode light power
source
antenna video front
rgb
comp1 comp2
1 2 3
4 5 6
7 8 9
0
enter
mute ratio
vol ch
swap pipch- pipch+ pip
flashbk surf freeze
menu
exit
skip
record stop
pause rew
play ff
2
1/3
2
3
206-03726