Pip/Pop/Split - Zenith D60WLCD Installation And Operating Manual, Warranty

PIP/POP/SPLIT

PIP (Picture in Picture) / POP (Picture out of
Picture) / SPLIT modes let you watch main pic-
ture and sub picture at the same time.
PIP/POP/SPLIT modes become off in cases below.
• In changing main source
• In changing Aspect Ratio
• In activating Channel Add/Del/Surf, Channel
Lable or Channel Block in Setup menu
• In activating Help menu
Press the PIP button on the remote con-
1
trol to activate PIP (Picture in Picture)
mode.
Press the LEFT/RIGHT arrow to select
2
CH+/-, Swap, Source or Move.
• CH+/- : Press the UP/DOWN arrow to
select a program of sub picture.
To change programs of sub picture is
possible only when PIP signal source
is NTSC RF signal.
If you want to change a program of
main picture, press pg up/dn button.
• Swap : Press the UP/DOWN arrow to
swap main and sub picture by.
• Source - Press the UP/DOWN arrow to
select a source of sub picture.
Your choices are : TV, Video1/2,
Front, Component1/2.
RGB-HD/STB and RGB-PC input cannot
used as PIP screen source.
• Move : Press the UP/DOWN arrow to
change the position of sub picture.
Press the EXIT button to exit PIP mode
3
or press the PIP button again to acti-
vate POP mode.
P A G E 2 4
vcr cable dvd sat
tv
mode light power
source
tv video front
rgb
comp1 comp2
1 2 3
4 5 6
7 8 9
0
enter
mute ratio
vol ch
swap pipch- pipch+ pip
flashbk surf freeze
menu
exit
skip
record stop
pause rew
play ff
2
1/3
2
3
206-3726