Griddle Burner Igniter; Griddle Control; Griddle Safety Valve - Monogram ZGP486ND Technical Service Manual

Griddle Burner Igniter

The griddle burner igniter is attached to the right
side of the griddle burner with two 1/4-in. hex-
head screws. It is necessary to remove the griddle
burner (See
Griddle Assembly
and the igniter wire harness. The griddle igniter
has a resistance value of 45 to 400 Ω at room
temperature.

Griddle Safety Valve

Note: The following describes the procedure to
remove the griddle safety valve. The griddle safety
valve has a resistance value of 1 Ω or less.
To remove the griddle safety valve:
1. Place the control panel in the service position.
(See .)
Control Panel
2. Remove the two 1/4-in. hex-head screws to
remove the bracket.
3. Disconnect the 2 wires from the valve.
4. Remove the heat barrier.
5. Remove the 9/16-in. nut from the valve.
Heat Barrier
6. Remove the two 5/16-in. hex-head nuts that
attach the valve to the chassis, then separate
the valve from the chassis and gas tube.
.), to access the screws
Bracket
Disconnect (1 of 2)
– 37 –

Griddle Control

The griddle control utilizes a capillary that senses
griddle temperature and a switch that operates the
LED indicator light. When the griddle knob is turned
to the ON position, the control closes contacts that
start the ignition process. The LED switch contacts
also close and activate the LED indicator light. The
LED switch can be replaced separately.
The griddle control is attached to a manifold
bracket.
To remove the griddle control:
1. Remove the griddle, then remove the capillary
retainer. (See
Griddle Assembly
Note: The griddle control fi ts tightly between the
manifold bracket and the front frame of the range.
2. Remove the 2 Phillips-head screws and the
griddle control from the manifold bracket.
3. Place the cardboard insulator aside.
4. Slide the LED switch and switch plate off the
control shaft.
.)
Cardboard Insulator
LED Switch
and Switch
Plate
(Continued next page)