Note:
•
A ground wire at each end of the panel allows
the panel to be lowered without falling.
•
Before lowering, protect the bottom of the front
panel from scratches caused by the lock motor
arm.
•
If the range has a grill, use caution when
lowering the control panel to prevent damage to
the switches mounted at the bottom of the grill
valve.
7. Pull the control panel straight out from the
chassis, then carefully lower the control panel
onto a protective, supportive surface.
Control Panel in Service Position
Grill Assembly
Note: The following describes the procedure to
remove the grill assembly.
To remove the grill:
1. Lift off the grill grate and grill frame.
2. Lift the grill baffl e straight up and remove it from
the 4 support posts located on the side walls.
(See
Control Features.
3. Remove the two 1/4-in. hex-head screws that
attach the igniter to the igniter bracket, then
place the igniter aside.
4. Remove the 2 Phillips-head screws that hold the
refl ector trim in place.
5. Lift up and remove the trim and screen.
– 31 –
)
(Continued next page)