Toshiba RAV-SM564UT-E Service Manual page 192

Toshiba SDI / DI tuotteiden jälleenmyyjä pääkaupunkiseudulla on Jäähdytinpalvelu RefGroup Oy.
No. Part name
1. Detachment
E-cover
3
1) Perform work 1. of
2) Take off screws fixing E-cover, and then
2. Attachment
1) Hang on E-cover to hooks of the hooking
NOTE)
Be sure not to catch TA sensor in the E-cover;
otherwise the equipment cannot operate
correctly.
2) Using the screws taken off in procedure 1. 2)
NOTE)
If there is clearance, dust may enter in the
electric parts box.
1. Detachment
E-box
4
1) Perform works 1. of
2) Remove clamps and tie wrap at upper part
3) Take off screws fixing E-box. (Ø4 × 10, 2 pcs)
4) Remove the E-box over sheeting metal
2. Attachment
1) Insert hooks of E-box into the hooking part
2) Store E-box as before, and then attach it by
NOTE)
Be sure to fix surely as before the lead wires of
which clamps and tie wrap were taken off.
NOTE)
Check that lead wires of the drain pump do not
reach the fan so that they are not caught in the
fan, and then fix them.
(In case of drain pump incorporated model)
Procedure
2 .
remove hooks of the hooking part by lifting
up. (Ø4 × 10, 2 pcs)
part so that it does not fall down.
of 3 , attach E-cover while holding it with
hands without clearance.
2 and 1. of
of the photo. (Drain pump incorporated
model: 3 positions)
(Natural drain model: 2 positions)
E-box does not fall down under condition
that screws are taken off.
which was fixed with screws.
of the main body.
using screws taken off in procedure 1. 3) of
4 .
www.ilmalämpöpumput.com
TA sensor
3 .
Drain pump
Lead wire:
For only drain pump incorporated model
– 192 –
Remarks
E-cover E-cover E-cover
2 screws
Hooking part
E-cover E-cover E-cover
Clamp
Tie wrap Tie wrap Tie wrap
2 screws
Clamp